.
A loud bang in the garage, a door that suddenly feels impossibly heavy, or a garage door that only lifts a few inches before stopping—these are classic signs you’re dealing with a broken spring. When that happens, your garage door isn’t just inconvenient; it can become unsafe to operate and can strain other components like cables, rollers, and your opener.
If you need garage door spring repair in Plantation, FL, M&M Garage Door Service provides professional service to get your door balanced, running smoothly, and operating safely again. Call (954) 787-3756 or visit https://mnmgaragedoorrepair.com/ to schedule service.
Why garage door springs matter
Your garage door is typically the largest moving object in your home. Springs do the heavy lifting by counterbalancing the door’s weight so it can be raised by hand or by an automatic opener with minimal effort.
When springs weaken or break, the door may:
– Feel extremely heavy or impossible to lift manually
– Open unevenly or crooked
– Stop midway and reverse
– Slam shut unexpectedly
– Put excessive strain on the opener, sometimes causing motor or gear failure
Because springs store significant torque, spring work should be handled by trained technicians using proper tools and safety procedures.
Torsion vs. extension springs: what’s in your garage?
Most residential doors in Plantation use one of two spring systems:
Torsion springs
Mounted horizontally above the door opening on a metal shaft. They wind and unwind as the door moves, providing smooth, controlled lifting power. Torsion setups are common on newer doors and many upgraded systems.
Extension springs
Mounted along the sides of the door tracks. They stretch as the door closes and contract as it opens. Extension springs often have safety cables running through them to reduce hazard if they snap.
The photo provided shows a technician working near the torsion spring line above the garage door—typical of a torsion spring service call.
Signs of a broken garage door spring
Homeowners often discover a spring failure suddenly. Common symptoms include:
– A loud bang: Many springs break with a sharp crack that sounds like a firecracker.
– Door won’t open: The opener may hum, try to lift, then give up.
– Door opens 6–12 inches and stops: The opener’s safety logic senses overload.
– Visible gap in torsion spring: A torsion spring often shows a clear separation where it snapped.
– Loose cables: When springs fail, cables can come off drums or go slack.
– Crooked or jerky movement: One spring may be broken while the other still has tension.
If you suspect a broken spring, stop using the door and call for garage door spring repair to prevent additional damage.
Is it safe to use the opener with a broken spring?
In most cases, no. A garage door opener is not designed to lift the full weight of the door. Continuing to press the button can:
– Burn out the opener motor
– Strip internal gears
– Bend the opener rail or trolley
– Cause cables to jump off the drums
– Increase the risk of the door dropping
For safety and cost savings, it’s best to shut the system down and schedule repair.
What’s included in professional garage door spring repair
When M&M Garage Door Service performs garage door spring repair in Plantation, FL, the goal is not only to replace a failed spring but to restore correct balance and safe operation.
A typical spring repair service includes:
1. System inspection: Confirm spring type, door weight, track condition, bearings, and cable status.
2. Spring selection: Proper sizing matters. Springs must match your door’s weight and height for correct cycle life and balance.
3. Safe spring replacement: Controlled tensioning and secure hardware installation.
4. Cable and drum check (torsion systems): Ensure cables are seated correctly and drums are aligned.
5. Balance test: The door should stay in place when lifted halfway.
6. Opener force and travel check: Verify the opener is not overworking and safety reversal is functioning.
7. Lubrication and operational test: Reduce noise and friction and confirm smooth movement.
Should you replace one spring or both?
Many doors have two springs. If one breaks, the other is often near the end of its life because both have done the same amount of work.
In many cases, replacing both springs at the same time provides:
– Better door balance
– Reduced strain on the opener
– More consistent performance
– Fewer future emergency calls
A technician can recommend the right approach based on what’s installed and the door’s condition.
Why garage door spring projects aren’t DIY
It can be tempting to watch a video and try to tackle spring work yourself, but torsion springs are under extreme tension. Improper handling can cause:
– Severe injury from an uncontrolled winding bar slip
– Damage to the shaft, drums, or end bearings
– Incorrect spring sizing that leads to door imbalance
– Premature failure of rollers, hinges, cables, or opener
Professional garage door technicians have the correct bars, clamps, and process to perform repairs safely.
What causes spring failure?
Springs are rated for a certain number of cycles (one cycle = open + close). Factors that reduce spring lifespan include:
– Normal wear and cycle count
– Humidity and corrosion (common in South Florida)
– Lack of lubrication
– Improper spring size
– Door imbalance or added weight (insulation, reinforcement, or new panels)
Regular maintenance can help, but eventually springs typically need replacement.
Preventing future spring problems
After your garage door spring repair, a few simple habits can extend component life:
– Lubricate springs and rollers with a garage-door-rated lubricant every few months
– Listen for squealing, grinding, or popping noises
– Keep tracks clean (but don’t grease the tracks)
– Test door balance periodically (only if safe and the spring is intact)
– Schedule routine inspections, especially if the door is used multiple times per day
Choose M&M Garage Door Service in Plantation, FL
When your garage door won’t open or you suspect a broken garage door spring, fast and correct repair matters. M&M Garage Door Service is a local, reliable option for homeowners and businesses needing safe, professional solutions.
M&M Garage Door Service
1611 NW 82nd Ave, Plantation, FL 33322
Phone: (954) 787-3756
Website: https://mnmgaragedoorrepair.com/
Email: mjmgaragedoor1958@gmail.com
Schedule garage door spring repair today
If your door is stuck, heavy, or you heard a loud snap, don’t force it. Get the spring system inspected and repaired by trained garage door technicians.
For garage door spring repair in Plantation, FL, contact M&M Garage Door Service at (954) 787-3756 or book online at https://mnmgaragedoorrepair.com/.
